Re-assemble the burner as follows:
^
Place the burner head m on to the
burner base n so that the ignition
safety device o and the ignitor p
extend through their respective holes
in the burner head. The burner head
must click into place correctly.
^
Replace the burner cap l ensuring
that the locating tabs fit into the
notches in the burner head m.
Important: replace parts in the correct
order after cleaning.
1. Do not replace parts upside down.
2. The locating tabs must fit exactly into
the notches.
Cleaning and care
22
To Next Page
Loading...
Need help?
General
