Miele PG 8059 - DOS Venting and Concentration Settings

Further settings
82
DOS venting
 To avoid damage to the dispensing system, make sure before
venting that the containers for cleaning agent and rinsing agent are
sufficiently filled and the dispensing siphons are screwed securely
to the containers.
 Select DOS venting and confirm your choice with theOK button.
The dishwasher will now start the automatic venting process of the
dispenser system.
Dispensing system DOS venting will appear in the display.
As soon as the process has finished, Dispensing system DOS
successfully vented will appear in the display.
 Confirm the message with the OKbutton.
Setting the DOS
concentration level
Please observe dispensing recommendations made by the
manufacturer of the agent.
 Select Concentration and confirm your choice with theOK button.
Concentration levels are given as a percentage and can be set
between 0.01 and 2.00%.
The concentration level set then applies to all programmes.
Display for DOS1:
Concentration
0,30 %
(0,01 - 2,00 %)
If a DOS G 60module is connected to the dishwasher, the factory
set concentration level must be reduced by half.
Display for DOS2 Rinsing agent and DOS4:
Concentration
0,04 %
(0,01 - 2,00 %)
 Use the arrow buttons  (higher)  (lower) to set the concentration
level you want and confirm your choice with theOK button.