Miele PG 8059 - Fault Codes and Programme Cancellation

Problem solving guide
100
Cancel with fault code
If a programme is cancelled and a fault code appears, e.g. Fault XXX (where XXX
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
 Switch the dishwasher off with the button.
 Wait approximately 10seconds before switching the dishwasher on again with the
button.
 Start the previously selected programme again.
If the same error message appears again:
 Make a note of the error message.
 Switch the dishwasher off with the button.
 Contact the Miele Customer Service Department.
Please also read the notes regarding the following fault codes.
Problem Cause and remedy
Fault 403-405 If Check water inlet appears in the display, the control unit
is checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the
dishwasher, one of these fault numbers will appear in the
display and the programme will be cancelled.
 Open the stopcock fully.
 Switch the dishwasher back on.
 Select the programme you want.
 Press the Start/Stopbutton.
Fault 406-408 Water inlet fault.
One of these fault numbers will appear in the display if the
flow pressure is too low and the programme will be
cancelled.
 The flow pressure at the water intake point is too low
(see “Technical data”). Contact Miele Service for advice.
Fault 412-414 Water inlet fault.
One of these fault numbers will appear in the display if the
flow pressure is too high and the programme will be
cancelled.
 The flow pressure at the water intake point is too high
(see “Technical data”). Contact Miele Service for advice.
Check drainage Drain fault. There might be water in the wash cabinet.
 Clean the filter combination (see “Cleaning and care”).
 Clean the drain pump (see “Maintenance”).
 Clean the non-return valve (see “Maintenance”).
 Remove any kink or loop in the drain hose.