Supervisor level
You can alter the access code to the
supervisor level.
^
Enter the old code.
^
Enter a new code.
After you have confirmed the new code,
the display will change to the beginning
of the Settings menu.
Display contrast
There are ten different display
contrast settings.
The machine is delivered with the
display contrast on Setting 4.
The display contrast will change as
soon as a different setting is chosen.
Display brightness
There are ten different display
brightness settings.
The machine is delivered with the
display brightness on Setting 5.
The display brightness will change as
soon as a different setting is chosen.
Standby (Display)
To save energy, the display goes out
after 10 minutes and the Start button
flashes slowly.
Turning the programme selector or
pressing a button switches the display
back on again.
There are three options:
On
Standby comes on:
–
if a programme is not selected after
the machine has been switched on.
– after a programme has started.
– after the end of a programme.
Not in current Prog.
(the machine is delivered with this
option selected)
Standby comes on:
– if a programme is not selected after
the machine has been switched on.
Settings/Supervisor level menu
71
To Next Page
Loading...
