Miele PW 814 User Manual

Programming
152
– Dispensing throughput (D1 to D13)
– Dispensing correction factor (D1 to D13)
– Dispenser level reminder (D1 to D13)
– Password
– Medium water pressure
– Heater power
– Customer data
– Currency
Save the specified parameters.
 Specify the parameters.
 Press the "Save" button to save the specified parameters.
The parameters are saved and the display switches back to the sub-
menu.
Useful tip: When is pressed, or if after 30 seconds no button has
been pressed, the settings are not saved and the display returns to
the main menu.
Memory function
The Temperature and Spin speed programme parameters for those
programmes which can be changed before the programme start, are
saved after the start of the programme. In addition, the button
functions are not reset at the end of the programme. These appear
again with each new programme selection.
Options:
– No
– Yes
Basic programme
lock
The programmes in this defined programme area cannot be changed,
deleted or overwritten.
Options:
– No
– User defined from: 1to999
Buzzer
If "Yes" is programmed, the buzzer is activated along with the
programme stop signal 1 and 2, the block end signal and the fault
stop signal. The buzzer frequency is increased with the fault stop
signal. The buzzer is automatically switched off after 5minutes or by
pressing a multifunction button.
If "No" is programmed, the buzzer is switched off.
Options:
– No
– Yes

Miele PW 814 Specifications

General

Brand	Miele
Model	PW 814
Category	Washer
Language	English