Programme chart
97
Ch. Th. Dis. cloths 70 °C Fill ratio/Load
size
Fabric Cotton, viscose, polyester and microfibre cloths
1:20
PW 811 - 5.6 kg
approx. 350
cloths
PW 814 - 7 kg
approx. 440
cloths
PW 818 - 9 kg
approx. 565
cloths
Programme
sequence
Pre-rinse
+ Pre-wash, optional
Disinfection 70°C, 10min.
3 rinses
Final spin
Ch. Th. Dis. cloths +
finish
70 °C
Fabric Cotton, viscose, polyester and microfibre cloths
Programme
sequence
Programme sequence as for Cloths chemo-
thermal disinfection Disinfection, then:
Finishing agent, damp or activate block:
Damp, wet, dripping wet
Finish cleaning cloths
Fabric Cotton, viscose, polyester and microfibre cloths
Programme
sequence
1 rinse
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
The programme Standard cloths is also suitable for cleaning cloths that are not to be
used immediately after washing, but are to be stored after drying.
With the Cloths . . .+ finish programmes the cloths are ready to use and already
impregnated with detergent and disinfectant. To achieve this, following washing or
disinfection there is a finishing stage and then a final spin. The desired moisture of the
cleaning cloths can be varied by programming different spin blocks at the end. Detergent
amounts must be set on site and the standard of disinfection must be checked.
The Finish cleaning cloths programme is suitable for the subsequent finishing of clean
and dry cloths. A disinfecting agent is applied during finishing. Detergent amounts must
be set on site and the standard of disinfection must be checked.
To Next Page
Loading...
Need help?
General
