Using the Electrobrush
The Electrobrush is particularly suitable
for intensive vacuuming of carpets
which are subject to hard wear. It is
very effective at removing deep seated
dirt and preventing areas of frequent
use being trodden into a path.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
The following should not be vacu
-
umed using the Electrobrush
– Floor surfaces with a variable or un-
even profile. The brush might come
into contact with the floor and cause
damage.
– Carpets such as saxony with very
long pile, berber and sheepskin
rugs, and valuable hand-knotted car-
pets, e.g. Persian and similar. There
is a danger that threads can be
pulled out.
Fitting the Electrobrush to the
vacuum cleaner
^
Insert the electro-telescopic tube into
the Electrobrush. (Ensure that the
plug connectors line up). They must
lock together with a click.
For further information on use and
maintenance please refer to the sepa
-
rate instructions supplied with the
Electrobrush.
Preparing for use
11
To Next Page
Loading...
