Fault Possible cause Remedy
The condenser unit
service panel will not
shut.
The inner cover of the
condenser unit has not
been locked properly
and/or the condenser unit
has not been positioned
correctly.
–
Ensure that the
condenser unit is
positioned correctly and
lock the cover.
–
Check the rubber seals.
Water leaks from the
machine after the
condenser unit has
been cleaned.
Fluff has collected at the
bottom of the condenser
unit housing.
–
Use a cloth to remove
any fluff from the inside
of the condenser unit
housing.
Check and fault indicator lights
Fault Possible cause Remedy
The Locked indicator
light flashes when the
appliance is switched
on and the
programme cannot be
started.
The system lock is
activated.
If you wish to use the dryer,
the system lock must be
deactivated (see
"Electronic system lock").
The Empty out
container indicator
light comes on.
The condensed water
container is full or there is
kink in the drain hose.
– Empty out the
condensed water
container.
–
Check the drain hose.
–
Switch the dryer off and
then on again.
Problem solving guide
33
To Next Page
Loading...
Need help?
General
