Fault Possible cause Remedy
Drying times are
too long.
The fluff filters and / or the
heat exchanger might be
clogged up.
– Clean as described in
“Cleaning and Care”.
Ventilation to and from
the dryer is insufficient
(e.g. in a small room) .
– Open a door or window
while the machine is
operating to increase air
flow.
The vent below the
door is blocked.
– Remove any objects that
are causing the blockage.
The laundry was not
sufficiently spun.
– Spin the laundry in the
washing machine at the
highest possible speed.
The dryer has been over
loaded.
– Observe the maximum
loads for the programme
selected.
Metallic components
e.g. zips have prevented
the dryer from
registering the correct
moisture level in the
laundry.
– Complete the drying
process using a Timed
Drying progamme
C .
If after checking all the above, drying times are still too
long, there may be a fault. Contact the Service Dept.
Problem solving guide
21
To Next Page
Loading...
