Changing the standard setting of a
drying program
Individual drying programs can be repro
-
grammed to meet special requirements. To
make program changes, the unit must be set
to the "basic position".
Basic position
^
The dryer must be off and the drum door
closed.
^
All buttons must also be in the "Off" posi
-
tion, i.e. released not pressed in.
^
The program selector must be at the "t
End" position.
^
Press in the "s On-Off" switch.
The "On" indicator will light.
^ Press the "L low temperature" button twice
in and twice out within 4 seconds:
The letter P lights up in the left field of the
additional display.
The program sequence indicator "Drying"
will light and "Cold air" will flash.
The unit can now be reprogrammed, see ex
-
amples 1 and 2 on the following pages.
Reprogramming
15
-
-
To Next Page
Loading...
