Additional display
Residual moisture Time Vented air
Display Displays the residual
moisture set for pro
-
grams A to I. A few
minutes after the pro
-
gram has started the
residual moisture in
the laundry is re-
corded and displayed.
The current residual
moisture values are
shown continuously
during the program.
Displays the time set
for program J or K.
The hours are shown
in the left display field
and the minutes in the
right fields. After the
program has started
the remaining run time
is shown instead of the
total time.
Displays the current
vented air temperature
for 5 seconds while a
program is running.
Selector button With this button the
programmed residual
moisture values in pro-
grams A to I can be
changed.
These changes can
only be made before
the start of the pro
-
gram. Changes are
only valid at the time
the program is se
-
lected. At the end of
the cycle the program
will revert to the preset
standards.
With this button the
program duration can
be changed in pro-
gram J (003 minutes
to 1.00 hour) and in
program K (003 min
-
utes to 3.00 hours).
These changes can
only be made before
the start of the pro
-
gram. Changes are
only valid at the time
the program is se
-
lected. At the end of
the cycle the program
will revert to the preset
standards.
If this button is
pressed in while a pro-
gram is running and
released immediately
the current vented air
temperature will ap
-
pear in the additional
display for 5 seconds.
Indicator lights
< Lights up when the
machine is turned on
and program A or I
is chosen. It goes out
at the end of the pro
-
gram.
m Lights up when the
machine is turned on
and a program be
-
tween J and K is
chosen. It goes out at
the end of the pro
-
gram.
Guide to the tumble dryer
8
To Next Page
Loading...
Need help?
General
