Setting Standby
To save energy, the display goes out
after 10 minutes and the indicator
light for the Start/Stop button will start
flashing slowly.
Reactivating from Standby
^
Turning the programme selector or
pressing one of the buttons switches
the display back on again. This will
not alter a running programme.
On
Standby is activated:
– if a programme is not selected after
the machine has been switched on.
– after a programme has started.
However: The display will switch on for
10 minutes if Delay start has finished,
after the end of a progamme or the
Anti-crease cycle.
The buzzer (if selected) will sound for
10 minutes after the end of a
progamme.
Factory default; Not in current
programme
As described under "On".
But: The display and indicator lights will
not switch off during a programme.
Off
The display and indicator lights will not
switch off when the dryer is switched
on.
Follow steps (A,B,C ...) to
programme and store in memory.
^ See the next page.
Programmable functions
58
To Next Page
Loading...
