Problem solving guide
35
Changing the lamp
Disconnect the tumble dryer
from the mains electricity supply.
Open the door.
You will find the interior lamp cover at
the top of the drum aperture.
Insert a suitable tool* under the side
edge of the lamp cover as illustrated.
* such as a wide flat bladed screwdriver
Apply a little pressure and whilst
doing so turn your wrist in the
direction of the arrow to open the
cover.
The cover will open downwards.
The temperature resistant lamp should
only be ordered from your Miele dealer
or the Miele Spare Parts Department.
The lamp must be replaced with
one of the same type and
specification. The light specification
and maximum wattage is stated on
the data plate and on the light cover.
Turn the lamp anti-clockwise to
remove.
Replace the lamp.
To close the cover push it upwards
and press it on the left and right until
you hear it click into position.
Ensure that it is fitted into
position securely, as any moisture
could cause a short circuit.
To Next Page
Loading...
