Buzzer
The buzzer has two volumes.
Normal
(Factory default)
The buzzer sounds at the end of a
programme.
Loud
The buzzer sounds at maximum volume
at the end of a programme.
Keypad tone
An audible tone sounds each time a
button is pressed.
Factory default: Off.
Contrast
Brightness
There are ten different display
contrast and display brightness
settings.
The bar chart shows you the setting.
Factory default: a medium setting.
Standby
To save energy, the display goes out
after 10 minutes and the indicator
light for the
Start/Stop
button will start
flashing slowly.
There are two options:
On
Standby is activated:
–
if a programme is not selected within
10 minutes of the machine being
switched on.
– 10 minutes after a programme has
started.
– 10 minutes after the end of a
programme.
not in current prog.
(Factory default)
– Standby is activated if a programme
is not selected within 10 minutes of
the machine being switched on and
after the end of a programme.
(Standby is not activated after a
programme has started).
Pressing one of the buttons switches
the display back on again.
Memory
The electronics will memorise the
drying level and any extra options
selected for the current drying
programme.
Factory default: Off.
Programmable functions
51
To Next Page
Loading...
Need help?
General
