Changing the programme sequence
33
You cannot change to another
programme once a programme has
started (this prevents unintentional
alterations).
If you try to change a programme,
lights up until the original programme is
reset.
Exception: You can switch the dryer off
by turning the programme selector to
the position.
You will need to cancel the current
programme before you can select a
new one.
Bear in mind that hot steam may
escape when the door is opened.
Cancelling a programme while
it is running and selecting a
new programme
Touch the Start/Stop sensor.
The items will be cooled down,
depending on the temperature reached
and how long they have been dried for.
will light up if you press the Start/
Stop sensor again during the cooling
down phase.
To cancel, turn the programme
selector to .
Select and start a new programme
straight away.
Adding or removing laundry
Touch the Start/Stop sensor.
The items will be cooled down,
depending on the temperature reached
and how long they have been dried for.
will light up if you press the Start/
Stop sensor again during the cooling
down phase.
Danger of burning!
Do not touch the back of the drum
when adding or removing items. The
drum and the items can be very hot.
Add or remove items.
Close the door.
To continue with the programme:
(select a drying level first, if necessary)
Touch the Start/Stop sensor.
Programme duration
Altering the programme sequence can
cause the programme duration shown
in the time display to be adjusted.
To Next Page
Loading...
Need help?
General
