Miele TCE 630 WP - Problem solving guide; Check indicators and fault messages

Problem solving guide
46
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Check indicators and fault messages
Problem Possible cause and remedy
 lights up after a
programme has been
cancelled and a signal
sounds
The condensed water container is full or there is a
kink in the drain hose.
 Empty the condensed water container.
 Check the drain hose.
 See "Cleaning and care".
To switch off :
 Open and close the door (with the dryer switched
on).
 lights up at the end
of a programme
There is a build-up of fluff in the airways.
 Clean the fluff filters.
 Clean the plinth filter.
 See "Cleaning and care".
To switch off :
 Open and close the door (with the dryer switched
on).