Problem solving guide
47
Problem Possible cause and remedy
lights up The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
Bars flash in the display
at the end of a
programme:
.........
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
flashes/lights up
after the tumble dryer is
switched on and a
programme cannot be
selected
Access via a code has been activated.
See "Programmable functions - Code".
and light up after
a programme has been
cancelled, a signal
sounds
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See "Cleaning and care".
To switch off :
Switch the dryer off and then on again.
and another number
combination flash after
a programme has been
cancelled, a signal
sounds
There is no obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme terminates again with the same
error message, then there is a fault. Contact Miele.
: lights up and the
programme has been
cancelled, a signal
sounds
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.
To Next Page
Loading...
