Problem solving guide
50
Problem Possible cause and remedy
A programme cannot be
started
There is no obvious cause.
Connect the tumble dryer to the mains electricity
supply.
Turn on the tumble dryer.
Close the door.
Check whether the mains fuse has tripped.
Has there been a power cut? When power is
restored, any previously running programme will
restart automatically.
Only the Start/Stop
sensor is flashing
10 minutes after the end of the programme, the Start/
Stop sensor will begin to flash and the display will go
out to save energy. This is not a fault, but a normal
function.
The drum will turn at intervals in the anti-crease
phase.
Touch a sensor to switch on the indicators.
See "Programmable functions", section " Control
panel switch-off status".
The dryer is switched
off at the end of the
programme
The dryer switches off automatically to save energy.
This is not a fault, but a normal function.
To switch the dryer on, select a programme.
You can change the automatic switch-off function.
See "Programmable functions", section " Dryer
switch-off status".
The interior drum
lighting does not come
on
The drum lighting will switch off automatically ...
... when the door is closed.
... after a few minutes when the door is open (to save
energy).
If the dryer is switched on, the drum lighting will
come on when the door is opened.
To Next Page
Loading...
