4. Selecting programme settings
33
The selected Delay start time has been
cancelled.
After the programme has started, the
selected Delay start time can only be
changed or cancelled by interrupting
the programme.
SmartStart
The SmartStart function (only
functional in selected countries) lets
you define a time period during which
your tumble dryer will start
automatically. The machine will start
on receipt of a signal, e.g. from your
energy supplier, that indicates that the
electricity rate is particularly
economical.
This function is active when the
SmartGrid setting is switched on.
The timeframe can be defined between
15 minutes and 24 hours. During this
period, the tumble dryer waits for the
signal from the energy supplier. If no
signal is sent during the defined period,
the tumble dryer starts the drying
programme.
Setting the timeframe
If you have activated the SmartGrid
function in Settings, SmartStart in
instead of Start in will appear in the
display when you touch the sensor
(see “Settings – SmartGrid”).
The procedure for setting this is the
same as for setting the time for Delay
start.
Use the sensors to enter the
hours and confirm your entry with the
OK sensor.
The hours will be saved and the minute
number block will be highlighted.
Use the sensors to enter the
minutes and confirm your entry with
the OK sensor.
Press the Start/Stop sensor to start
the drying programme with
SmartStart.
The following will appear in the display:
To Next Page
Loading...
Need help?
General
