EasyManua.ls Logo

Miele TMG 440 WP - Airway and Container Error Messages

Miele TMG 440 WP
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem solving guide
51
Problem Cause and remedy
Clean out airways lights
up at the end of a
programme
There is a build-up of fluff in the airways.
Clean the fluff filters.
Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
Confirm with OK.
Clean out airways See
lights up after a
programme is cancelled
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways:
clean the area underneath the plinth filter
clean the heat exchanger.
To switch off the message:
Switch the dryer off and back on again.
Empty container see
lights up after a
programme is cancelled
The condensed water container is full or there is kink
in the drain hose.
Empty the container.
Check the drain hose.
To switch off the message:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Fill condensate container This is to remind you that water is taken from the
condensed water container when the Steam
smoothing programme is being used.
The condensed water container must be filled with
water to at least the –min– marker.
Confirm with OK.
Open & close door This it to remind you to load the laundry when the
Steam smoothing programme is selected.
Load the laundry in the drum.
Comfort cooling The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.

Table of Contents

Related product manuals