Miele TMG 440 WP - Buzzer Volume; Keypad Tone; Conductivity; Total Consumption

Settings menu
78
Buzzer volume
The buzzer can be set to be louder or
quieter.
The setting selected is shown in a bar
chart.
Factory default: a medium setting.
– Quieter       
– Louder       
You will hear the buzzer change as the
setting is selected.
Keypad tone
When this function is activated a tone
will sound each time a button is
pressed.
Options
– On
– Off (factory default)
Conductivity
 In some areas of the UK, water is
extremely soft which can affect the
sensitivity of the electronics. If the
dryer is installed in an area with very
soft water, you should contact your
local water supplier for information
and advice regarding water hardness
and water conductivity. If the water
conductivity is less than 150 μS, the
Low option for the Conductivity
setting will need to be activated.
Options
– Normal (factory default)
– Low
Important
This option should not be activated if,
despite the water being extremely soft
(as would be the case if a water
softener were used), its conductivity is
greater than 150 μS.
 Only activate the Low option if
the above conditions are present.
Otherwise drying results will be
unsatisfactory.
Total consumption
You can display the total
consumption.
Options
– Display
The total consumption is displayed in
kWh.
– Reset functions
The total consumption to date will be
deleted with the Reset option.