Problem solving guide
48
Problem Cause and remedy
flashes/lights up
after the tumble dryer
has been switched on
and a programme can-
not be selected
Access via a code has been activated.
See “Programmable functions - Code”.
and light up after
a programme has been
cancelled, a signal
sounds
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See “Cleaning and care”.
To switch off:
Switch the dryer off and then on again.
and another number
combination flash after
a programme has been
cancelled, a signal
sounds
No obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
: lights up and the
programme has been
cancelled, a signal
sounds
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.
To Next Page
Loading...
