Miele TSB 143 WP - Memory, Anti-crease, and Indicators

Programmable functions
76
 Control field standby status
To save energy, the time display and
sensor controls will go out once the
programme has been running for
10minutes. In this case, the Start/Add
laundry sensor control flashes slowly.
However, there is no switch-off in the
event of a fault.
Options
 = Off
The time display and sensor
controls do not go out.
 = On (factory default setting)
The time display and sensor
controls will go out once the
programme has been running
for 10minutes.
“Switching on” the display again
– Touch the Start/Add laundry sensor
control. This will not affect a running
programme.
 Memory
You can set the following: The elec-
tronic module will save the drying level
and any options selected for the cur-
rent drying programme. It will also
save the duration of the Warm air pro-
gramme. When the programme is se-
lected again, these saved settings will
appear in the display.
Options
 = Off (factory setting)
 = On
Exception:
The Cottons  programme will re-
main unchanged.
 Anti-crease
The drum will continue to rotate in a
special anti-crease rhythm for a max-
imum of 2 hours after the end of the
drying process. This helps prevent
creasing if laundry is not going to be
removed immediately. You can reduce
the duration of the anti-crease phase.
Options
 = no Anti-crease
 = 1 hour
 = 2 hours (default setting)