Miele TXD 160 WP - Door Hinge Conversion Procedure

Installation
*INSTALLATION*
70
Changing the door hinging
Preparation
This tumble dryer is delivered with the
door hinging installed on the right-
hand side. You can change the door
hinging over to the left-hand side.
To do this, you will need:
- a Torx T20 screwdriver
- a Torx T30 screwdriver
- a soft surface (e.g., a blanket)
 For safety reasons, the tumble
dryer must be disconnected from the
electricity supply (pull out the
electrical plug).
Tip: Before starting work, read the
following text and review the images.
Then complete the following steps in
the sequence described.
Removing the door
You will need a Torx T30 screwdriver.
 Open the door of the tumble dryer
fully.
 Use the Torx screwdriver to unscrew
the two screws on the base plate
of the door hinge.
The door cannot fall off.
 Place the twoscrews on the lid of the
tumble dryer.
 Take a firm hold of the door.
 Pull the door forward so that you can
pull the twopins out of the base plate
of the door hinge.
 To avoid scratching the door, place it
on the blanket outer side down.