Cleaning and care
55
Cleaning the plinth filter
Clean the plinth filter when the
program duration has been extended
or when this message appears in the
display: Clean the lint and plinth filters.
See the Operating Instructions for more
information.
To delete the message:
Confirm with OK.
Removing the plinth filter
Press the round, indented area on the
heat exchanger access panel to open
it.
The flap will spring open.
Pull the plinth filter out by the handle.
The right-hand guide pin comes out
when the plinth filter is removed. The
guide pin prevents the flap from closing
without the plinth filter.
To Next Page
