Frequently Asked Questions
58
With the help of the following guide, minor faults in the performance of the
machine, some of which may result from incorrect operation, can be remedied
without contacting the Service Department. This will save you time and money
because you won't need a service call.
This guide may help you find the reason for the fault and help you correct it.
The display indicates messages or faults
Message Possible cause and solution
000 lights up after
switching on.
Access via a PIN code has been activated.
Enter the code and confirm the entry. Deactivate
the PIN code if you do not wish this message to
appear in the display the next time the machine is
switched on.
Finish/Cooling Down The laundry will be cooled down at the end of the
program.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Fault F. If restart
fails, contact Service
lights up after a
program has
been cancelled.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program terminates again with the same fault
message, then there is a fault. Contact Miele Service.
Fill condensate
container with water
Water is taken from the condensed water container
when the SoftSteam program is being used. The
condensed water container must be filled with water
to at least the –min– marker.
Fill the condensed water container as described
under “Condensed water container”.
To switch off the message: press OK.
Please open and
close the door
This it to remind you to load the laundry when the
SoftSteam program is selected.
Load the laundry in the drum.
To Next Page
