Miele TXR 860 WP - Volume; Display Brightness; Display off Status

Settings
92
Volume
The volume can be changed for the
buzzer that sounds when the dryer is
switched on and at the end of the
program. The volume of the buzzer
that sounds when a sensor button is
touched can also be changed.
Options
- Finish tone
- Keypad tone
- Welcome Tone
It can be set to one of 7 different levels
or switched off altogether.
Display brightness
The brightness of the display can be
altered.
They can be set to one of 7 different
levels.
medium setting (factory setting)
“Display” off status
To save energy, the display and
sensor buttons will go out after
10minutes and the Start/Stop button
will flash slowly. You can alter this
setting.
Options
- Off
The display will remain on (i.e., it will
never go out).
- On
The display will go out (after
10minutes):
– if a program is not selected after
the dryer has been switched on
– during the current program
– at the end of a program
- On -Not in current prog.
(Factory setting)
The display will go out (as described
above) but will remain on while the
program is running.
You can switch the display back on by
touching any sensor button.