Miele WDB004 - Faults and Indicator Lights

Problem solving guide
48
The programme is cancelled and a fault indicator light lights up
in the control panel
Problem Cause and remedy
The fault indicator light
 lights up,  and  ap-
pear alternately in the
time display and the
buzzer sounds.
The water inlet is blocked or restricted.
 Check whether the stopcock is opened properly.
 Check whether the inlet hose is kinked.
 Check whether the water pressure is too low.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator light
 lights up,  and  ap-
pear alternately in the
time display and the
buzzer sounds.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum delivery head is 1m.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water protection system has reacted.
 Close the stopcock.
 Call the Service Department.
 and  alternately
appear in the time dis-
play and the buzzer
sounds.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching off at the wall
socket and withdrawing the plug, or by discon-
necting the relevant fuse on the mains fuse board.
 Wait at least 2minutes, before reconnecting the
washing machine to the mains electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact the
Service Department.