Miele WSA 023 Active - Page 32

Programme chart
32
Outerwear Cold to 40°C Max. load 2.5kg
Items Performance outerwear (e.g. jackets and trousers) made from mem-
brane fabric such as Gore-Tex®, SYMPATEX®, WINDSTOPPER®,
etc.
Tip – Zip up or close any jackets with Velcro before washing.
– Do not use fabric conditioner.
– If required, these items can also be re-proofed using the Proof-
ingprogramme. Proofing after each wash cycle is not recommen-
ded.
Proofing 40°C Max. load 2.5kg
Items Treating microfibre fabric, ski wear or table linen made from mainly
synthetic fibres to provide a finish which is resistant to water and dirt
Tip – The items must be freshly laundered and spun or dried before
proofing.
– For best results, the items should be heat-treated afterwards. This
can be achieved by drying them in the tumble dryer or ironing
them.
Drain/Spin –
Tip – Drain only: Set spin speed to.
– Make sure you select the appropriate spin speed.
Separate rinse/Starch Max. load 7.0kg
Items – Rinsing hand-washed items
– Table cloths, serviettes and workwear requiring starching
Tip – Reduce the final spin speed for fabric that creases easily.
– Laundry that is to be starched should be washed but not treated
with fabric conditioner.
– Items will be rinsed very effectively with 2rinses by activating the
Water + extra option.