Miele WSD 663 Selection - Removing the Transit Bars

96 pages

Save Page as PDF

To Next Page

To Previous Page

Installation

*INSTALLATION*

Removing the transit bars

Removing the left-hand transit bar

 Push the cover out and turn the left-

hand transit bar 90° using the span-

ner supplied.

 Withdraw the transit bar.

Removing the right-hand transit bar

 Push the cover out and turn the left-

hand transit bar 90° using the span-

ner supplied.

 Withdraw the transit bar.

Main Page

Table of Contents2
Caring for the Environment6
Warning and Safety Instructions7
Operating the Washing Machine14
Control Panel14
How the Control Field Works15
Before Using for the First Time16
Miele@Home17
Remove the Transit Bars18
Setting up Miele@Home18
Commissioning Twindos19
Starting the Calibration Programme20
Washing Environmentally and Economically21
Prepare the Laundry22
Select a Programme23
Load the Washing Machine24
Select Programme Settings25
Add Detergent26
Degree of Soiling of the Laundry27
Replacing Detergent Cartridges27
Detergent Dispenser Drawer28
Capdosing30
Starting the Programme32
Adding Laundry During a Programme Sequence (Addload)32
End of Programme33
Spinning34
Delay Start/Smartstart35
Programme Chart37
Extra Options40
Short40
Pre-Ironing40
The Following Extra Options Can be Selected in Addition to the Programmes40
Garment Care Label Symbols41
Programme Sequence42
Changing the Programme Sequence44
Changing a Programme (Safety Lock)44
Cancelling a Programme44
Detergent45
The Correct Detergent45
Water Softeners45
Dispensing Aids45
Fabric Conditioner and Liquid Starch45
Recommended Miele Detergents46
Recommended Detergents in Accordance with Directive (EU) Nr. 1015/201047
Cleaning and Care48
Cleaning the External Casing and the Control Panel48
Cleaning the Detergent Dispenser Drawer48
Hygiene Info(Cleaning the Drum)50
Cleaning the Water Inlet Filter50
Twindos Maintenance51
Problem Solving Guide52
The Programme Does Not Start52
The Programme Is Cancelled and a Fault Indicator Light Lights up in the Control Panel53
During the Programme Sequence, a Symbol Appears in the Time Display54
At the End of the Programme, an Indicator Light Lights up in the Control Panel55
Messages or Faults with the Twindos System56
General Problems with the Washing Machine57
An Unsatisfactory Wash Result59
The Door will Not Open60
Opening the Door in the Event of a Blocked Drain Outlet And/Or Power Cut61
Service63
Contact in the Event of a Fault63
Optional Accessories63
EPREL Database63
Warranty63
Installation64
Front View64
Rear View65
Installation Surface66
Transporting the Washing Machine to Its Installation Site66
Removing the Transit Bars67
Fitting the Transit Bars69
Levelling the Machine70
Screwing out and Adjusting the Feet70
Installing under a Continuous Worktop71
Washer-Dryer Stack71
The Water Protection System72
Connection to the Water Supply72
Water Drainage74
Electrical Connection75
Technical Data76
EU Conformity Declaration77
Consumption Data78
Programmable Functions79
Choosing and Selecting a Programmable Function79
Editing and Saving a Programmable Function80
Exit Programming Level80
Sensor Tone80
Lock Code81
Control Panel Switch-Off Status81
Memory82
Longer Pre-Wash Cottons82
Gentle Action82
Reduce Temperature82
Maximum Rinse Level83
Suds Cooling83
Anti-Crease83
Low Water Pressure83
Backlight Brightness Dimmed84
Twindos84
Ultraphase 1 Dispensing Quantity84
Ultraphase 2 Dispensing Quantity84
Twindos Maintenance85
Degree of Soiling85
Networking86
Remote Control86
Smartgrid86
Remoteupdate87
Switching off Wifi88
Copyrights and Licences for the Communication Module88
Detergents and Care Products89
Detergent89
Specialist Detergents90
Fabric Care91
Additives91
Machine Care91

Miele WSD 663 Selection - Removing the Transit Bars

Table of Contents

Related product manuals