Miele WSI 863 - Code; Units; Brightness

Settings
99
Code
The PIN code prevents the washing
machine being used without your
knowledge.
Selection
– Activate
If you activate the PIN code, you
have to enter a PIN code after
switching the washing machine on.
Otherwise it cannot be operated.
The factory default PIN code is 125.
– Change
If wished, you can set a different
three-digit PIN code.
 Do not forget the code you have
set.
If you forget the code, only Miele
Technical Service can unlock the
washing machine.
Make a note of your new code.
– Deactivate
The washing machine is to be oper-
ated again without entering a PIN
code. This only appears if the PIN
code had been activated previously.
Units
The temperature can be displayed as
degrees °C/Celsius or °F/Fahrenheit.
The factory default is °C/Celsius.
Brightness
You can set the brightness of the dis-
play, the sensor controls and the
dimmed sensor controls.
Selection
– Display
Controls the brightness of the dis-
play.
–       (dark)
–       (light) (factory default)
– Buttons active
Controls the brightness of the activ-
ated sensor controls.
–       (dark)
–       (factory default)
–       (light)
– Buttons inactive
Controls the brightness of the sensor
controls that can be activated.
–       (dark)
–       (factory default)
–       (light)
Tip: Ensure that there is a discernible
difference in brightness between the
activated and dimmed sensor controls.
A big difference in brightness makes it
easier to operate the appliance.