F Start the programme
^
Press the flashing Start/Stop button.
The estimated programme duration will
count down in the display in one minute
steps. During the first 10 minutes the
machine measures how much water is
being absorbed by the laundry. The
programme duration may be longer or
shorter depending on this absorbency
rate.
The programme sequence is also
shown in the display. The washer-dryer
shows you when each section of the
programme is reached.
The drum lighting switches off once the
programme has started.
G Remove the laundry when the
programme has finished
In the anti-crease phase after the
programme has finished, the following
will appear alternately in the display:
Anti-crease
and
i
Programme finished.
Remove laundry, then
switch the machine off.
^
Turn the programme selector to the
Stop position. Press the Door button
to open the drum door.
^
Remove the laundry.
Only remove laundry from the
machine once the drum has stopped
turning. Reaching into a moving
drum is extremely dangerous and
could result in injury.
Check that all items have been
removed from the drum. Items left in
the drum could discolour other items
in the next wash or become
discoloured themselves.
Important! Always remove the
laundry before switching the machine
off. This is important to ensure that
the load size indicator works
correctly.
^ Switch the machine off with the I-On/
0-Off button.
See "After each washing or drying
programme" for further information.
After washing a full load
If you have washed a full load of
laundry and you wish to dry the
laundry in the washer-dryer
afterwards you will have to remove
half the load. Carry out the drying
procedure in two batches.
WASHING
20
To Next Page
Loading...
Need help?
General
Weight and Dimensions
