^
Open the drum door fully.
,
Warning, the metal cap located
on the inside of the door glass is
very hot after drying. Do not touch
it. Danger of burning!
^
Remove the laundry.
^ Check the folds in the door seal for any
small articles, e.g. buttons which might
be lodged there. Remove any fluff from
drying from around the door seal.
Check that all items have been
removed from the drum. Items left
behind could colour run, shrink or be
damaged in the next washing or
drying programme.
Important: Always remove the laundry
before switching the machine off. This
is important to ensure that the load
size indicator works correctly the next
time the machine is used.
^
Switch the machine off with the I-On/
0-Off button.
^
Close the door. Otherwise there is the
danger of objects being placed
inadvertently in the drum. If these
remained unnoticed and were
washed or dried in the next load, they
could damage the laundry.
After drying
Rinse out fluff programme
The fluff which occurs during drying
can collect in the drum and also in the
suds container. It is best to rinse out this
fluff before the machine is used again
so that it cannot be deposited on the
next load (e.g. fluff from dark garments
being deposited on lighter coloured
items) or cause a blockage.
The Rinse out fluff programme must
not
be used for rinsing laundry. Make
sure that there is no laundry in the
drum before starting this programme.
^ Switch the machine on.
^
Turn the programme selector to the
Rinse out fluff programme.
^
Press the Start/Stop button.
The fluff will be rinsed out after a few
minutes.
^
Remove any remaining fluff from
around the door seal.
^
Switch the machine off.
The load size sensor must be
recalibrated to zero after running the
Rinse out fluff programme. See
"Before using for the first time" for
instructions on how to do so.
After each washing or drying programme
43
To Next Page
Loading...
Need help?
General
Weight and Dimensions
