Miele WWE760 - Page 22

Before using for the first time
22
Settings for compartment 
The UltraPhase2 values are pre-set in
the standard settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for 
OK





 Confirm with the OK sensor.
Miele UltraPhase 2
OK




 Confirm with the OK sensor.
The dispensing quantity for
UltraPhase2 is pre-set for  (hard-
ness range II).
Per load
OK




ml45
 Confirm the pre-set value with the OK
sensor or correct the value with the
 sensors and confirm this with the
OK sensor.
UltraPhase2
 Hardness level I 36 ml
 Hardness level II 45 ml
 Hardness level III 54 ml
The following will appear in the display:
 Insert 
 Remove the stopper from the deter-
gent cartridge.
 Push the UltraPhase2 detergent
cartridge into compartment until
it locks into position.
When the cartridge is pushed in, the
display message switches to:
 "TwinDos" is set. Can be changed in "Set-
tings".
 Confirm with the OK sensor.
 Close the TwinDos access panel.