Miele WWR860WPS PWash2.0&TDosXL&WiFi - Connecting the Water Inlet Hose

Installation
*INSTALLATION*
93
The washing machine should be con-
nected to the mains water supply in ac-
cordance with current local and national
safety regulations. The German authorit-
ies do not require it to have a non-return
valve as the washing machine has been
designed to comply with DIN regula-
tions.
The water-connection pressure needs
to be between 100kPa and 1000kPa. If
the water-connection pressure exceeds
1000kPa, a pressure reducing valve
must be installed.
A stopcock with a ¾ inch threaded
union is required for the connection. If
this is not available, only a qualified in-
staller may connect the washing ma-
chine to the mains water supply.
The washing machine is not suitable
for connection to a hot water supply.
The washing machine must not be
connected to a hot water supply.
Connecting the water inlet hose
 Screw the water inlet hose onto the
thread of the water inlet with the nut.
To prevent damage to the inner hose,
keep a tight hold of the valve housing
and only turn the nut.
 Slowly open the stopcock and check
the connection for leaks.
 Correct the position of the seal and
screw thread if necessary.