USER’S MANUAL MIG
____________________________________________________________________
____________________________________________________________________________________
MATT di LIEVORE SRL Via Bianche 7 36010 Carre’ ( VI ) Tel. 0445 / 892223 Fax 0445 / 390346
11. ELECTRONIC EQUIPMENT L1 (220V)
INTRODUCTION
The electronic equipment Type S1R can be used to control one actuator for a sliding
gate. The max. absorption of the device is 600W per 230V 50Hz. The set-up of the
parameters must be carried out after the installation of all the equipment.
DESCRIPTION
TR1 – TR4 = Trimmers
DSW1 = Dip switches
DL1-DL8 = LED
F1 = Line 230V fuse
F2 = Low voltage fuse
M1 = Signal terminal board
M2 = Power terminal board
CN2 = Antenna terminal board
K1-K3 = Relais
TF1 = Transformer
U1 = Microprocessor
JR1 = Reset jumper
To Next Page
Loading...