EasyManua.ls Logo

MIG 400 - 2. Installation; Preliminary Gate Checks; Power Supply Cable Specifications

MIG 400
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USER’S MANUAL MIG
____________________________________________________________________
____________________________________________________________________________________
MATT di LIEVORE SRL Via Bianche 7 36010 Carre( VI ) Tel. 0445 / 892223 Fax 0445 / 390346
1. GENERAL OUTLINE
Electromechanical operator designed to automate residential-type gates. The
operator keeps the gate blocked on closing and on opening, without needing an
electric lock. The operator has no mechanical clutch. It must be controlled by an
electronic control panel provided with torque setting. The end-of-stroke operation
is managed by the control panel.
GROUND is a series of powerful and silent gearboxes made for the automatic
movement of the winged gates and doors up to 3 meters for the leaf. GROUND OIL
and GROUND 24 V version, prepared for intensive use, are an ideal choice for
condo applications.
2. INSTALATION
Preliminary checks
Check that:
• The gate structure is sufficiently sturdy.
• Also make sure that the actuator pushes against the leaf reinforced section.
• The leaves move manually and without effort all along their stroke.
• The door stop plates are fitted at the end of both closing and opening strokes.
If the gate has not been recently installed, check the wear condition of all
components.
• Repair or replace faulty or worn parts.
- moto-riduttore una piazzola in cemento.
Power supply cable
The board power supply cable must be of the H 05 RN-F type or equivalent. The
equivalent cable must guarantee:
- permanent outside use
- rated voltage of 300/500 V