USER’S MANUAL MIG
____________________________________________________________________
____________________________________________________________________________________
MATT di LIEVORE SRL Via Bianche 7 36010 Carre’ ( VI ) Tel. 0445 / 892223 Fax 0445 / 390346
Fit an omnipolar or magneto thermal switch on the mains power supply, having a contact
opening distance equal to or greater than 3,5 mm.
Check that a differential switch with a 0.03A threshold is fitted just before the power supply
mains.
Check that earthing is carried out correctly: connect all metal parts for closure (doors, gates
etc.) and all system components provided with an earth terminal.
Fit all the safety devices (photocells, electric edges etc.) which are needed to protect the area
from any danger caused by squashing, conveying and shearing.
Position at least one luminous signal indication device (blinker) where it can be easily seen,
and fix a Warning sign to the structure.
The Company declines all responsibility with respect to the automation safety and correct
operation when other manufacturers’ components are used.
Only use original parts for any maintenance or repair operation.
Do not modify the automation components, unless explicitly authorized by the company.
Instruct the product user about the control systems provided and the manual opening
operation in case of emergency.
Do not allow persons or children to remain in the automation operation area.
Keep radio control or other control devices out of children’s reach, in order to avoid
unintentional automation activation.
The user must avoid any attempt to carry out work or repair on the automation system, and
always request the assistance of qualified personnel.
Check that the stated temperature range is compatible with the place where the operator is
to be installed.
If present, the hold button (hold-to-run control) must be fitted within sight of the door but
away from the moving parts, at a height of 1.5 m, and must not be accessible to the public.
If the operator is fitted at a height lower than 2.5 m, you must guarantee an adequate degree
of protection for the electrical and mechanical parts.
Make sure that squashing is avoided between the moving parts and surrounding fixed parts.
Fit all the safety devices (photocells, safety edges etc.) required to protect the area from any
danger of squashing, drawing in and shearing.
After completing the installation, ensure that the motor is set correctly and that the
protection and release systems operate correctly.
Anything which is not expressly provided for in the present instructions is not allowed.
To Next Page
Loading...