USER’S MANUAL MIG
____________________________________________________________________
____________________________________________________________________________________
MATT di LIEVORE SRL Via Bianche 7 36010 Carre’ ( VI ) Tel. 0445 / 892223 Fax 0445 / 390346
GENERAL SAFETY
If correctly installed and used, this automation device satisfies the required safety level
standards.However, it is advisable to observe some practical rules in order to avoid acci-
dental problems.
Before using the automation device, carefully read the operation instructions and keep them
for future reference.
Keep children, people and things outside the automation working area, particularly during its
operation.
Keep radio control or other control devices out of children’s reach, in order to avoid any
unintentional automation activation.
Do not intentionally oppose the leaf movement.
Do not modify the automation components.
In case of malfunction, disconnect the power supply, activate the emergency release to have
access to the automation and request the assistance of a qualified technician (installer).
Before proceeding to any outside cleaning operation, disconnect the power supply.
Keep the photocell optical components and light signal devices clean.
Check that the safety devices (photocells) are not obscured by branches or shrubs.
For any direct assistance to the automation system, request the help of a qualified technician
(installer).
Have qualified personnel check the automation system once a year.
Manual release activation could cause the door to be subject to uncontrolled movements in
the case where any mechanical faults are present or the door is not balanced.
Inspect the installation frequently if it shows any unbalance or signs of mechanical damage to
cables and supports”. Do not use the operator if it needs to be repaired. Keep the
instructions together with the technical brochure for future reference.
This product was exclusively designed and manufactured for the use specified in the present
documentation. Any other use not specified in this documentation could damage the product
and be dangerous.
The Company declines all responsibility for any consequences resulting from improper use of
the product, or use which is different from that expected and specified in the present
documentation.
Do not install the product in explosive atmosphere.
The construction components of this product must comply with the following European
Directives: 2004/108/CEE, 2006/95/EEC, 98/37/EEC and subsequent amendments. As for all
non-EEC countries, the above-mentioned standards as well as the current national standards
should be respected in order to achieve a good safety level.
The Company declines all responsibility for any consequences resulting from failure to
observe Good Technical Practice when constructing closing structures (door, gates etc.), as
well as from any deformation which might occur during use.
The installation must comply with the provisions set out by the following European
Directives: 2004/108/CEE, 2006/95/EEC, 98/37/EEC and subsequent amendments.
Disconnect the electrical power supply before carrying out any work on the installation. Also
disconnect any buffer batteries, if fitted.
To Next Page
Loading...