Migatronic PI 200 User Manual

QUICKGUIDE PI
200 I 250 I 350 I 500
DK
5013716 A
TIG DC panel til brug for svejsning i alle
materialer undtagen aluminium og dets
legeringer. Panelet muliggør endvidere
MMA svejsning med gængse elektrode-
typer. Knappernes funktioner er beskrevet
på modsat side.
TIG DC panel med HF-tænding uden
pulsfunktion. Knappernes funktioner er
beskrevet på modsat side.
MMA/350 CELL panel til brug for tradi-
tionel elektrodesvejsning med gængse
elektrodetyper eller 350 CELL til svejsning
med celluloseelektroder. Panelet giver
mulighed for enkel TIG svejsning med
LIFTIG
®
tænding. Knappernes funktioner
er beskrevet på modsat side.

Migatronic PI 200 Specifications

General

Welding Current Range, TIG	5-200 A
Open Circuit Voltage	96 V
Protection Class	IP23
Output Current Range	5-200 A
Rated Output Current	200 A
Welding Current Range, MMA	20-200 A
Standards	EN 60974-1, EN 60974-10

Summary

AC/DC Control Panel Functions

Core Welding Selections

Select welding process (MMA/TIG), trigger mode, ignition method (HF/LIFTIG), and current type (AC/DC).

Current and Arc Adjustments

Adjust welding current, arc voltage, start/stop amps, and idle current for precise control.

Timing and Gas Flow Control

Configure gas pre-flow/post-flow times, slope-up/down times, and spot welding time.

Pulse Welding Settings

Control traditional and quick pulse modes, including pulse timing, pause time, and base current.

Specialized Welding Techniques

Utilize TIG-A-Tack for tack welding and Synergy PLUS™ for optimized welding.

MMA Specific Features

Configure Hotstart for increased starting current and Arc Power for arc stability.

AC Welding Parameters

Adjust AC-t-balance, AC frequency, electrode preheating, and AC-I-balance.

Advanced Control Features

Manage secondary parameters and Intelligent Gas Control (IGC) for enhanced welding.