Need help?Do you have a question about the Migatronic Focus Tig 200 AC/DC and is the answer not in the manual?
General| Input Voltage | 230 V |
|---|---|
| Output Current Range | 5-200 A |
| AC Frequency | 50/60 Hz |
| Fuse | 16 A |
| Protection Class | IP 23 |
| Power Supply | Single-phase |
| Efficiency | 85% |
| Pulse Welding | Yes |
| AC/DC | Yes |
| Duty Cycle at 40°C | 60% |
| Duty Cycle | 100% |
| Cooling Method | Fan cooled |
| Welding Process | TIG |
| Standards | EN 60974-1 |
| Rated Output | 200 A |
Set welding current by pressing the key and turning the control knob.
LED indicates voltage on MMA electrode or TIG torch.
LED indicates when the relevant parameter unit is active.
LED indicates when the machine is overheated.
LED indicates if mains voltage is too high or too low.
Choice between MMA and TIG welding processes.
Choice between 2-stroke and 4-stroke trigger modes.
Choice of HF or LIFTIG® ignition.
Setting for gas pre-flow and post-flow times.
Time from welding current to stop current.
Activate pulse mode and adjust pulse time, pause time, base current.
Choice of AC or DC welding current.
Adjust AC time balance and automatic electrode preheating.
Access parameters 10, 11, and 12 for further adjustments.
To Next Page