What to do if my Migatronic Welding System shows H2O error?
If your Migatronic Welding System displays an H2O error, it indicates a cooling fault. Check that the cooling hoses are correctly connected, top up the water tank, and inspect the welding hose and branches. You can reset the error message by pressing the MMA keypad.
Why does my Migatronic PI 350 PLASMA Welding System show E04-02 error?
The E04-02 error on your Migatronic Welding System indicates a mains supply fault. To resolve this, connect the welding machine to a 400V AC power source, ensuring it's within the +/-15% range at 50-60Hz.
What does PLS error mean on my Migatronic Welding System?
The PLS error on your Migatronic Welding System indicates a plasma hose error. You should repair or replace the hose.
What does PLG error mean on my Migatronic Welding System?
If your Migatronic Welding System displays a PLG error, it indicates a plasma gas error, which causes the welding process to stop and the text PLG flashes on the display.
Why does my Migatronic Welding System show Fdr error?
The Fdr error on your Migatronic Welding System indicates a communication error, meaning the PI PLASMA and CWF unit are disconnected.
Connect the machine to the correct mains supply and read the type plate.
Connect gas hoses to a supply with pressure regulators for shielding and plasma gas.
Steps for starting, selecting processes, and initiating welding.
Explains indicators for temperature, voltage, mains, and general faults.
Lists error codes, causes, and recommended solutions for common issues.
General| Input Voltage | 3x400V |
|---|---|
| Duty Cycle | 100% at 350 A |
| Weight | 28 kg |
| Mains frequency | 50/60 Hz |
| Operating frequency | 50/60 Hz |
| Protection class | IP23 |
| Enclosure class | IP23 |
| Mains voltage +/- 15 % | 400 V |
To Next Page
