Battery Charging
It can be charged with standard AC power (AC 110-220 V, 50-60 Hz). Make sure to turn
off the power of the handbike before charging.
Insert the charging plug of the charger into the charging port on the lower front of the
control panel and insert the battery charging port to charge (the battery can be
removed and charged separately, or it can be directly charged on the handbike).
1. Insert the charger plug into the network power supply. When the red indicator light
is on, it means it is charging.
2. The red indicator light is on to indicate that it is charging. When the charger
indicator turns from red to green, keep charging for another 30 minutes to ensure
that the battery is fully charged.
3. After charging is completed, unplug the network power socket first, and then
unplug the charging plug.
4. Please charge at 0-45°C in an environment suitable for charging.
Over Discharge Protection Device
When the battery of the handbike is exhausted, the over-discharge protection device
will protect the battery from over-discharge. The user should note that the maximum
speed will decrease when the over-discharge protection device is activated. In this
case, please charge the battery as soon as possible.
Over current protect device
This handbike also equipped with an overcurrent protect device. If the current
supplied to the motor becomes excessive, the electronic fuse will turn off the current.
When driving a handbike in trouble, overcurrent protection will be activated, and the
driving wheels of the wheelchair will be blocked in motion. This process is the fuse cut
off the current to prevent the motor from overheating and damage.
To Next Page
Loading...