MikroTik BaseBox Series User Manual (English)

To Next Page

To Previous Page

Remove top cover;

Unscrew two screws on the back of the device;

Open Ethernet port cover and withdraw it from the base of the device;

Unscrew the antenna connector;

Withdraw the PCB plate from the base cover;

Install your modem and reassemble.

Reset button

The reset button has three functions:

Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds).

Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will now look for a CAPsMAN server (total 10

seconds).

Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15

seconds).

Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.

Useful for RouterBOOT debugging and recovery.

Need help?

Do you have a question about the MikroTik BaseBox Series and is the answer not in the manual?

MikroTik BaseBox Series Specifications

General

CPU core count	1
Storage size	16 MB
Storage type	FLASH
Operating System	RouterOS
License level	4
Max Data Rate	300 Mbps
Wireless 5 GHz Max data rate	300 Mbps
Antenna connectors	2 RP-SMA
Wireless Standards	802.11n
Antenna	2 RP-SMA
PoE in	Yes
Supported input voltage	11 V - 30 V (PoE in)
Weight	331 g