MikroTik CRS354-48P-4S+2Q+RM User Manual

Reset button
The RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when the green LED starts flashing, to reset the RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause a device to look for Netinstall servers (required for reinstalling RouterOS over
the network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
Please visit wiki pages for MikroTik SFP module compatibility table: https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table
Operating system support
The device supports RouterOS v6. The specific factory-installed version number is indicated in the RouterOS menu /system resource. Other operating
systems have not been tested.
Safety Notice
Electric shock hazard. This equipment is to be serviced by trained personnel only.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
Netinstall needs to be performed through the MGMT port on this device.
To avoid pollution of the environment, please separate the device from household waste and dispose of it in a safe manner, such as in
designated waste disposal sites. Familiarize yourself with the procedures for the proper transportation of the equipment to the designated
disposal sites in your area.

MikroTik CRS354-48P-4S+2Q+RM Specifications

General

Switch type	Managed
Switch layer	L3
Form factor	1U
Certification	CE/RED, EAC, RoHS
Rack mounting	Yes
Console port	RJ-45
SFP+ module slots quantity	4
QSFP+ module slots quantity	2
Installed SFP modules quantity	-
Fast Ethernet (copper) ports quantity	1
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
Power over Ethernet (PoE) voltage	53 V
Power over Ethernet (PoE) power per port	30 W
Operating temperature (T-T)	-20 - 60 °C
Memory type	Flash
Flash memory	16 MB
Internal memory	64 MB
Processor model	Qualcomm Atheros QCA9531
AC input voltage	100 - 240 V
Power consumption (max)	800 W
Power consumption (typical)	85 W
Networking standards	IEEE 802.3af, IEEE 802.3at
Cables included	AC
MAC address table	- entries

Weight and Dimensions

Depth	382 mm
Width	443 mm
Height	44 mm