Use a Phillips screwdriver to loosen the metal ring.
Slide one end of it through the most convenient of the three mounting slots.
Position the device on the pole where it will be mounted.
Slide the loose end of the mounting ring back to its closing latch and use the screwdriver to tighten it.
It's recommended to secure Ethernet cable to the pole using zip ties. With the distance from the device
approximately 30 cm.
As an additional option, you can use "quickMOUNT-X" – mounting bracket for an easy adjustment that
can be obtained separately. Product web page:https://mikrotik.com/product/qm_x
Specially designed enables vertical and horizontal adjustment on the pole.
Grounding
The device includes a grounding connection (marked ) which you should connect to the grounding ⏚
installation of the tower or building where the device will be used. This is to substantially reduce the risk
of ESD and lightning damage.
Powering
The device accepts DC power from Passive PoE injectors (one power supply and PoE injector are ⎓
included) accepts 12-28 V DC consuming at maximum load 4 W.⎓
Connecting to a PoE Adapter:
1. Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
2. Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
3. Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Extension Slots and Ports
10/100 Ethernet port.
Integrated 5 GHz 802.11a/n/ac interface with built-in antenna.
WiGig chipset QCA6335.
To Next Page
Loading...
