Reset button
The routerBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when green LED starts flashing, to reset RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause the device to look for Netinstall
servers (required for reinstalling RouterOS over the network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button
is pressed before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Accessories
Package includes the following accessories that come with the device:
EU/US Switching Power Supply 24V DC , 0.8 A, 9 W, Level VI, cable:1.5 m.⎓
POE Injector with shielded ethernet cable/connector (RBPOE).
Cube mount.
K-70 Fastening set for Cube mount.
Operating system support
The device supports RouterOS software versionv6.47.2. The specific factory-installed version number is
indicated in the RouterOS menu /system resource. Other operating systems have not been tested.
Notes
This device meets the Maximum TX power limit per ETSI regulations. The frequency and the maximum
transmitted power in the EU are listed below: 57-66GHz: 34.92 dBm. An Operational mode in the 60
GHz band: 58.32 GHz, 60.48 GHz, 62.64 GHz, 64.80 GHz. This device is certified for outdoor use in Point
to Multipoint applications. In the following countries this device cannot be used in Fixed Point-to-Point
applications:
Federal Communication Commission Interference Statement
FCC ID:TV7CB5A60
To Next Page
Loading...
