MikroTik hAP ax lite User Manual (English)

To Next Page

hAP ax lite

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

The Installation of the equipment must comply with local and national electrical codes.

This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.

This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.

Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.

Read the installation instructions before connecting the system to the power source.

We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your

own risk!

In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an

uncontrolled environment.This MikroTik device should be installed and operated no closer than 20 centimeters from your body, occupational user, or the

general public.

Quickstart

Please follow these quick steps to set up your device:

Make sure your Internet service provider is allowing hardware change and will issue an automatic IP address;

Connect your ISP cable to the first Ethernet port;

Connect the device to the included power adapter;

Connect your computer to the wireless network;

Open in your web browser to start the configuration;https://192.168.88.1

User name: and there is no password by default

admin

(or, for some models, check user and wireless passwords on the sticker);

Click the "Check_for_updates" button on the right side and update your RouterOS software to the latest version. The device must have an active

Internet connection;

The device will reboot;

Connect againand choose your country on the left side of the screen, to apply country regulation settings;

Set up your wireless network password, the password must be at least eight symbols;

Set up your router password in the bottom field to the right and repeat it, it will be used to log in next time.

MikroTik mobile app

Other manuals for MikroTik hAP ax lite

Quick Guide58 pages

Need help?

Do you have a question about the MikroTik hAP ax lite and is the answer not in the manual?

MikroTik hAP ax lite Specifications

General

Product Name	MikroTik hAP ax lite
Category	Network Router
CPU core count	4
RAM	256 MB
Storage	16 MB
Storage type	FLASH
Operating System	RouterOS
Wireless Standards	802.11a/b/g/n/ac/ax
Wireless 2.4 GHz	Yes
Wireless 2.4 GHz number of chains	2
Ethernet Ports	5
Number of 1G Ethernet ports with PoE-out	1
PoE out	802.3af/at
Input Voltage	12-28 V
PoE in	802.3af/at
Architecture	ARM