1.
2.
3.
4.
5.
SXT kit-series
SXT kit series models:
SXT 4G kit
SXT LTE6 kit
SXT LTE kit-US
SXT LTE kit
The SXT kit comes as a complete set and includes a built-in modem, connected to a built-in antenna. It has two 10/100 Ethernet connectors that support
MDI-X auto-detection. There are two micro SIM card slots available, to switch between cell providers.
First use
The default configuration is CPE RouterMode:
*LTE interface connected to providers network (WAN port);
*WAN port is protected by a firewall and enabled DHCP client.
LAN Configuration:
IP Address 192.168.88.1/24 is set on the bridge (LAN port)
DHCP Server enabled;
DNS: enabled.
WAN (gateway) Configuration:
gateway: lte1;
ip4 firewall: enabled;
NAT: enabled.
Open the bottom lid.
Insert the SIM cards into the micro-SIM slots (SIM A slot is a default).
If using another slot, the configuration can be changed in RouterOS with CLI command:
/system routerboard modem set sim-slot=down
After changing SIM slots, LTE modem will be restarted. It can take some time (depending on modem and board around 30 seconds) to fully
initialize it, so make sure you test your modem.
https://wiki.mikrotik.com/wiki/Dual_SIM_Application
Connect the device to the power source (see " ").SXT kit-series#Powering
Once the device is powered on and PC connected to the device, open in your web browser or Winbox to start the http://192.168.88.1
configuration.
User name: a and there is no password by default you will be logged in automatically to the Quick Set screen.
dmin
To Next Page
Need help?
General
