MikroTik MANTBox 52 15s

User Manual - mANTBox 52 15s
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be
familiar with standard practices for preventing accidents.
Read the installation instructions before connecting the system to the power source.
This equipment is to be installed by trained and qualified personnel, as per these installation
instructions. The installer is responsible for obtaining any required local or national safety inspections
of the structural integrity of the installation by the local authority/inspection department.
All installation methods for mounting an access point on any wall surface are subject to the acceptance
of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully
before beginning installation.
Failure to use the correct hardware and configuration or to follow the correct procedures could result in
a hazardous situation to people and damage to the system.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device.
Please use this product with care and operate at your own risk.
This device needs to be upgraded to RouterOS v6.46 or the latest version to ensure compliance with
local authority regulations.
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC, IC, and
European Union radiation exposure limits set forth for an uncontrolled environment. This MikroTik
device should be installed and operated no closer than 20 centimeters from your body, occupational
user, or the general public.
First use
1. Open cover (see Opening cover).
2. Connect the Ethernet cable from your PC to the Ethernet port.
3. Plug the device into the power source (see Powering).

MikroTik MANTBox 52 15s Specifications

General

Frequency band	2.4/5 GHz
Networking standards	IEEE 802.11b, IEEE 802.11g
Antenna gain level (max)	15 dBi
Mounting	Pole
Antenna type	Sector antenna
Polarization	Dual polarization
Antenna connector type	-
Power consumption (max)	21 W
Operating temperature (T-T)	-30 - 70 °C
Quantity per pack	1 pc(s)
Harmonized System (HS) code	85177100

Weight and Dimensions

Depth	140 mm
Width	348 mm
Height	82 mm

Summary

Safety Warnings

Exposure to Radio Frequency Radiation

Device complies with RF exposure limits, maintain 20cm distance from body.

First Use Guide

Powering the Device

Connecting to a PoE Adapter

Steps to connect the device using a PoE adapter.

Mounting Instructions

Device Configuration

Grounding and Protection

Opening the Device Cover

Expansion Slots and Ports

Buttons and Jumpers

Included Accessories

Operating System Support

Federal Communication Commission Statement

Antenna Installation Warning

Installer's responsibility for using certified antennas and proper configuration.

List of Approved 2.4 GHz Antennas

Approved antennas for 2.4 GHz band with models and gain.

List of Approved 5 GHz Antennas

Approved antennas for 5 GHz band with models and gain.

Innovation, Science and Economic Development Canada

Antenna Installation Warning

Installer's responsibility for using certified antennas in Canada.

List of Approved 2.4 GHz Antennas

Approved antennas for 2.4 GHz band with models and gain.

UKCA Marking

Eurasian Conformity Mark

Norma Oficial Mexicana Compliance

Ukraine Communications Regulation

CE Declaration of Conformity

Frequency Bands Terms of Use

Usage restrictions for different frequency bands in EU member states.